// RF_KNOWLEDGE_BASE — REGULATIONS & CERTIFICATION
← Back to RF FAQ How do you set up DTM firmware control for RF compliance testing on PCBs too small for normal test points?
// RF_DB_QUERY: RESOLVED
SYS_OK
Incorporate miniature pogo-pin landing pads (Tx, Rx, GND) on the bottom layer of the PCB. During testing, dock the board into a custom pogo-pin test fixture to run Direct Test Mode (DTM) commands.
// NEED_RF_ENGINEERING_SOLUTION?
Are you facing custom hardware design or RF interference challenges? 31NS-Tech leverages over 20 years of real-world expertise to engineer specialized solutions.
Request Technical Consultation